10.2 Configuring Your PC for IPv6
IPv6 is supported by Windows Vista and Windows XP Service Pack 1 or later. If using Windows XP, use the
procedure below to enable your PC for IPv6.
1. Click [Start]®[All Programs]®[Accessories]®[Command Prompt].
2. When the [Command Prompt] is displayed, enter ipv6 install. When installation is complete,
[Succeeded.] will be displayed.
3. Confirm that IPv6 was successfully enabled, enter ipconfig. If IPv6 addresses are displayed, installation
was successful.
For Windows XP Service Pack 2 or later users
If you use Windows XP Service Pack 2 or later, the following procedure is also necessary.
1. Click [Start]®[Control Panel]®[Security Center]®[Windows Firewall]®[Advanced] tab.
2. Click the [Settings...] button under [ICMP].
3. Check [Allow incoming router request], then click [OK].
Operating Instructions 189
10.2 Configuring Your PC for IPv6
To Next Page
Loading...
