2.3 Disabling and Enabling a Trigger
After configuring an image buffering trigger, you can later disable the trigger to temporarily turn it off, and enable
it to turn it on again. While disabled, a trigger will not buffer images, transfer images, or send trigger notification.
Note
• When you enable or disable a trigger, all images for all triggers buffered in the memory are deleted.
1. Click the [Setup] tab.
2. On the left side of the screen under [Buffer/Transfer], click [Trigger].
3. Click a trigger number (1–5).
4. Uncheck [Enable Image Buffer/Transfer] to disable the trigger.
• To enable a trigger you disabled earlier, check [Enable Image Buffer/Transfer].
5. Click [Save].
• All images buffered are deleted when you click [Save].
Operating Instructions 59
2.3 Disabling and Enabling a Trigger
To Next Page
Loading...
