8.2 Confirming Wireless Status (BL-C230 Only)
You can confirm various wireless information on the [Wireless Status] page such as:
– The status of the wireless connection to the wireless router
– The MAC address of the camera’s wireless module
– The quality of the wireless communication between the camera and the wireless router
The information displayed on this page can help you when the camera is not functioning in wireless mode as
you expect it to. Refer to this information for troubleshooting assistance.
1. Click the [Maintenance] tab.
2. On the left side of the screen under [Maintenance], click [Wireless Status].
3. Confirm the desired information.
Note
• If your wireless router uses MAC address filtering, enter the MAC address of the camera and the MAC
address of the camera’s wireless module when setting your wireless router’s MAC address filtering
feature. The MAC address of the camera’s wireless module is displayed on the [Wireless Status] page
next to [MAC address of Wireless module]. You can confirm the camera’s MAC address on the
[Status] page (see Page 176).
• The signal strength of the wireless connection to the wireless router is displayed next to [Radio
Condition] as follows:
– [Good]: When the signal strength is 50%–100%
– [Normal]: When the signal strength is 15%–49%
– [Weak]: When the signal strength is 1%–14%
– [No connection]: When there is no signal (0%)
• If you still cannot access the camera in wireless mode, see 1.4 Wireless Connection Issues (BL-C230
Only) in the Troubleshooting Guide.
• See the Panasonic Network Camera support site (http://panasonic.net/pcc/support/netwkcam/) for
details about the information displayed on this page.
Operating Instructions 177
8.2 Confirming Wireless Status (BL-C230 Only)
To Next Page
Loading...
