5.1.2 Proxy Server Settings
The following settings are necessary if your network uses a proxy server and you want to transfer images by
HTTP or send trigger notifications by HTTP. If you do not use a proxy server, these settings are unnecessary.
Note
• Consult your Internet Service Provider (ISP) or network administrator to find out if your network uses
a proxy server.
• The camera does not use encryption when sending the login ID and password to access the proxy
server. Use caution as necessary to prevent disclosure of this information.
• For added security, we recommend periodically changing the login ID and password that are required
to access your proxy server.
1. Click the [Setup] tab.
2. On the left side of the screen under [Basic], click [Network (IPv4)].
3. Under [Proxy Server Settings], enter the address
*1
port no., login ID
*2
and password
*2
that are required to
access the proxy server.
• Ask your ISP or network administrator for the correct settings.
• An IPv6 address can be specified; note that the IPv6 address must be enclosed in brackets.
4. Click [Save].
*1
[Space], ["], ['], [&], [<], and [>] cannot be used.
*2
["] cannot be used.
118 Operating Instructions
5.1.2 Proxy Server Settings
To Next Page
Loading...
