Preparing to register the camera to a TV (registration mode)
You can also set the camera to registration mode by pressing and holding the camera’s PRIVACY button for
about 3 seconds, until the AV LINK indicator flashes. If the camera is not registered to a TV within 5 minutes,
registration mode is canceled.
1. Click the [Setup] tab.
2. On the left side of the screen under [Advanced], click [Registered Devices].
3. Click the [Registration Mode] button when registering the camera to another device.
• You may now register the camera to the TV. Refer to the Setup Guide (for VIERA Connection) for
details.
• The AV LINK indicator flashes orange while the camera is in registration mode.
• After 5 minutes, registration mode is cancelled if the camera has not been registered to a TV.
Note
• Registration mode cannot be turned on while the camera is in privacy mode (see Page 170).
• The camera can be registered to up to 4 TVs.
• While the camera is in registration mode:
– No camera images are buffered or transferred.
– The built-in alarm does not sound.
– Privacy mode cannot be turned on.
Operating Instructions 173
7.7 Managing Registered Devices (BL-C210A/BL-C230A Only)
To Next Page
Loading...
