– 640 ´ 480: 35 KB (280 Kbit)
f. Under [Connection Type], select the appropriate connection type.
• Normally you can leave this setting at [Auto Negotiation].
• This setting is effective for both IPv4 and IPv6 connections.
2. Click [Save].
3. When the [New settings are saved.] message is displayed, click [Restart].
Note
• The current network settings can be confirmed on the [Status] page (see Page 176). You can also
confirm the camera’s IPv6 address using the Setup Program.
192 Operating Instructions
10.3 Configuring Your Camera for IPv6
To Next Page
Loading...
