uploaded file may be saved as “Image20090618173020500.jpg”.
The time stamp format is Year/Month/Date/24-hour time/Second/Millisecond.
Therefore, in this example, the file was captured on June 18, 2009, at 5:30 PM and 20 seconds
and 500 milliseconds. Note that if you configure the camera to adjust its time setting for Daylight
Saving Time/Summer Time (see Page 140), an “s” will be inserted between the date and time of
the time stamp.
h. Select the transfer method required to upload files to the server.
• Select [Passive Mode] normally. If files are not uploaded properly, change the setting to [Active
Mode].
2. Follow the procedure below based on the settings you made when configuring the trigger.
a. If you selected to not send notification when the camera is triggered, click [Save], then click [Go to
Trigger page].
b. If you selected to send notification when the camera is triggered, click [Next].
• The appropriate notification settings page is displayed.
– For E-mail notification, see Page 69.
– For HTTP notification, see Page 72.
*1
[Space], ["], ['], [&], [<], and [>] cannot be entered.
*2
["] cannot be entered.
62 Operating Instructions
2.4.1 Transferring Images by FTP
To Next Page
Loading...
