• As a general guideline, the number of post-trigger images should not exceed the total number of images
that can be buffered by the trigger minus 2 times the number of pre-trigger images.
(“C” equals or is less than “A”-(2´“B”), as shown above).
• Note that when using the above settings, the actual number of images buffered (“D”) is less than the
maximum number of images that can be buffered by the trigger (“A”).
• If the value set for post-trigger images is set too high, pre-trigger images may be overwritten.
• If the value set for pre-trigger images is set too high, images may not be buffered as expected.
80 Operating Instructions
2.8 Understanding How the Camera Manages Buffered Images
To Next Page
Loading...
