Panasonic BL-C210 Series

b. Under [Active Time], select the days and the time you want the camera to send alarm logs.
c. Under [Notice setup of an alarm log], enter the IP address or the host name
*1
of the SMTP server
(outgoing mail server).
• An IPv6 address can be specified; note that the IPv6 address must be enclosed in brackets.
• This feature cannot transfer images to web-based mail servers, such as Hotmail.
d. Enter the port number used by the server. (Port 25 is normally used for sending E-mail.)
• Some ISPs require outgoing mail to be sent using port 587 or using SSL (SMTP over SSL) on port
465. Ask your ISP or network administrator for the appropriate setting.
e. Enter the reply E-mail address
*2
that will be shown to the recipient as the sender of the E-mail.
• In an effort to reduce spam, many ISPs block E-mail sent through the SMTP server from an E-mail
address that is not associated with the SMTP server, therefore, we recommend entering the E-mail
address assigned to you by your ISP.
f. Enter the destination E-mail address
*2
. Up to 3 addresses can be entered.
g. Enter the subject
*2
that will be displayed in E-mail messages sent by the camera (max. 44 characters).
4. Under [How to authenticate], select the authentication method your ISP requires for sending E-mail, and
enter the appropriate settings if necessary.
– [No authentication]: Select this option if the outgoing E-mail server does not require authentication
when sending E-mail messages.
88 Operating Instructions
2.12 Sending Alarm Log Information