106
Modem
z Setting for [System standby]
*1
• Roughly consider the communication time and then set [System standby]. There
may be cases where the computer enters the standby mode after the time set for
[System standby] elapses, even during communications, and cuts off the
communications
• If [Never] is set, the computer will not enter the standby mode during
communications; but once the computer resumes, the power will remain on, even
while the user is absent.
z When the Ring Resume function is in use, some time elapses before a connection is
established (equal to the time for the computer to resume). To allow the computer to
resume, set the "Call" to a larger value than a typical telephone call. If it is not possible
for the sending side to set a long "Call", set the "Number of rings until answer" (with
the software application to maintain the condition to receive telephone calls) to a small
value.
*1
To display the setting for [System standby]:
Click [start] - [Control Panel] - [Performance and Maintenance] - [Power Options] - [Power
Schemes].
NOTE
z This function does not work when the computer is off or is in hibernation mode
z After operations are resumed from standby mode, the screen remains dark. The
former screen display will be restored when the keyboard or touch pad is touched
z The computer cannot resume if a telephone is connected to the modem line (e.g., a
PC Card modem) other than the internal modem
To Next Page
Loading...
Need help?
General