Panasonic CF-W2 Series

124
Setup Utility
*1
This is displayed only when an SD memory card has been registered.(Î page 85)
NOTE
z When the Setup Utility is started up with the User Password:
• [Clear registered SD card], [Set Supervisor Password] and [Hard Disk Lock] will not
be displayed
• [Password on boot], [SD Startup], [SD Setting Method], [Setup Utility Prompt], [Boot
First Menu] and [User Password Protection] will be displayed, but cannot be set
• The User Password can be changed only when [User Password Protection] has
been set to [No Protection]. The User Password cannot be deleted
Security Menu
Password on boot: [Enable]
SD Startup:
*1
[Enable]
SD Setting Method:
*1
[Leave Set]
XClear registered SD card:
*1
[Enter]
XSet Supervisor Password: [Enter]
Setup Utility Prompt: [Enable]
Boot First Menu: [Enable]
Hard Disk Lock: [Disable]
User Password Protection: [No Protection]
XSet User Password: [Enter]