125
Setup Utility
Parameters
(An underline indicates the factory default settings)
Password on boot
z Select whether you will need to input ([Enable]) or not
([Disable]) the Supervisor Password or the User Password on
booting
Disable
Enable
SD Startup
*2
z Select whether to use an SD memory card instead of entering
the password on booting ([Enable]) or not ([Disable])
Disable
Enable
SD Setting Method
*2
z Select whether to set an SD memory card to [Leave Set] or
[Set and Eject] when an SD memory card is used instead of
entering the password
z This can be set only if [SD Startup] has been set to [Enable]
Leave Set
Set and Eject
Clear registered SD card
z Clear the registration from all registered SD memory cards not
to be used instead of entering the password on booting
To the sub-menu
Set Supervisor Password
z Set a Supervisor Password if you wish to prevent any
unauthorized changes to the Setup Utility settings, also if you
require a password on boot, set [Password on boot] to
[Enable] after you set Supervisor Password
To the sub-menu
Setup Utility Prompt
z Select whether to display ([Enable]) or not to display
([Disable]) the message “Press F2 for Setup/F12 for LAN”
shown on the bottom of the [Panasonic] boot screen that is
displayed after starting this computer
Disable
Enable
Boot First Menu
z Select whether to display “Boot Menu” ([Enable]) or not
([Disable]) (Î page 127)
Disable
Enable
To Next Page
Loading...
