47
Security Measures
NOTE
z When the Supervisor Password has not been set, the User Password cannot be set.
Set the Supervisor Password if you have not done so (Î page 45)
z To disable the User Password, start up the Setup Utility with the Supervisor Password
1 Run the Setup Utility. (Î page 117)
2 Using either the Î key or the Í key, select [Security].
3 Using either the Ï key or the Ð key, select [Set User Password] and
press the
Enter
key.
4 Only when the User Password has been set:
Enter your password at [Enter Current Password] and press the
Enter
key.
5
Enter your password at [Enter New Password] and press the
Enter
key.
z To disable the User Password
Press only the
Enter
key
6 Re-enter your password at [Confirm New Password] and press the
Enter
key.
z To disable the User Password
Press only the
Enter
key
7 At [Setup Notice], press the
Enter
key.
To Next Page
Loading...
