91
SD Memory Card Security Function
If the Function fails to Operate Correctly
z The computer does not respond properly when you insert the SD memory card.
Remove the card and wait a few seconds, then reinsert it. Or, enter each password
z The SD memory card indicator is blinking.
Enter the password through the keyboard without removing the SD memory card.
A software application, etc. may be accessing the SD memory card
z The password input screen and the Windows log-on screen do not appear.
If [Leave set] was selected as the setting method:
• If an SD memory card is already inserted when starting the computer, each screen
does not appear when the computer is started
• If an SD memory card is already inserted when resuming from the standby or
hibernation mode, or while the screensaver is active, reinsert it
When logging on to Windows / When resuming from the standby or hibernation mode,
or the screensaver
z If [Set and eject] was selected as the setting method:
Insert the SD memory card, then eject it after you hear a beep indicating card recognition
(When the speaker function is disabled, e.g., by the key combination
Fn
+
F4
, there will be
no beep sound)
Change the Settings
After you run the SD Card Setup program once, the setup screen that appears the next time
you run it will be different.
1 Start the SD card setup program. (Î page 86, steps1-3)
The current settings will be displayed.
2 Change the settings.
A. Setting for this computer
You can change the settings registered in this computer.
To Next Page
Loading...
Need help?
General