Panasonic DP-3510

181
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
J33 The Registration Sensor detects paper during non-printing mode. C
J40 The Fuser Unit Paper Exit Sensor does not detect paper within a predetermined time
after the Registration Sensor is activated.
C, D
J41 The Fuser Unit Paper Exit Sensor does not go off within a predetermined time after
the Sensor is activated.
C, D
J42 The Fuser Unit Paper Exit Sensor detects paper during non-printing mode. C, D
J43 The Exit Sensor does not detect paper within a predetermined time after the Fuser
Unit Paper Exit Sensor is activated.
C, D
J44 The Exit Sensor keeps detecting paper after a predetermined time. C, D
J45 The Exit Sensor keeps detecting paper after a predetermined time, during non-
printing mode.
C, D
J50 The Inverting Exit Sensor does not detect paper within a predetermined time after the
Inverting Roller starts turning.
C, D
J51 The Exit Sensor does not detect paper within a predetermined time after the Inverting
Exit Sensor is activated.
C, D
J52 The Inverting Exit Sensor keeps detecting paper within a predetermined time after the
Inverting Exit Sensor is activated.
C, D
J53 The Inverting Paper Sensor keeps detecting paper within a predetermined time,
during non-printing mode.
C, D, E
J54 The Inverting Paper Path Sensor keeps detecting paper within a predetermined time,
during non-printing mode.
E
J55 The Inverting Exit Sensor keeps detecting paper within a predetermined time, during
non-printing mode.
C, D
J60 1. The Finisher Registration Sensor does not detect paper within a predetermined
time after Exit Sensor is activated.
2. The Finisher Registration Sensor keeps detecting paper within a predetermined
time after Finisher Registration Sensor is activated.
3. The Finisher Exit Sensor does not detect paper within a predetermined time after
Finisher Registration Sensor is activated.
4. The Finisher Exit Sensor keeps detecting paper within a predetermined time
after Finisher Exit Sensor is activated.
5. The Finisher Registration Sensor or the Finisher Exit Sensor keeps detecting
paper.
6. The next paper was detected while the current paper is still in the Finisher.
7. The Finisher Door was opened while the paper is passing through the Finisher.
H
J61 The stapler is not activated correctly. H
J62 The Paper is Jammed in the Inverter. H
J63 1. The Paper Path Sensor does not detect paper within a predetermined time in the
Saddle.
2. The Paper Path Sensor keeps detecting paper in the Saddle.
3. Either one of the above Sensors keeps detecting paper in the Saddle during
non-printing mode.
4. The Saddle Door was opened while the paper is passing through the Finisher.
I
J64 The Puncher is not activated correctly. H
J70-79 (See the following table below)
J80 The Automatic Duplex Unit (ADU) Entrance Sensor does not detect paper within a
predetermined time.
D, E, F
J81 The ADU Intermediate Sensor does not detect paper within a predetermined time
after ADU Entrance Sensor is activated.
F
Jam Error Codes (J Code) Table
Code Contents Section