Panasonic DP-3510

409
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(10) Place the Punch Relay Harnesses into a
Harness Clamps and Harness Guides.
(11) Attach the Front Cover, Latch Release Lever,
Jam Clear Dial, and Rear Cover.
Note:
When attaching the Front Cover, attach it as the
Side Guide is set inside the Front Cover. See the
figure left.
If the Front Cover is attached with the Side Guide
being set outside, up and down operation of
Ejection Tray may malfunction.
(12) Loosen the 2 Screws securing the Finisher and
Finisher Frame.
Punch Relay
Harness
(Orange)
Harness
Guide
Harness
Clamp
Punch Relay
Harness
(Violet)
Finisher
Controller
Circuit
Board
Side
Guide
Front Cover
Screws