Panasonic DP-3510

599
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
2. Removing the Feed Drive Unit.
Fig. 5-017
(1) Remove the Finisher Controller PCB.
(See Fig. 5-028.)
(2) Remove the Harness Leads [2] from 2 Harness
Stops [1] at the PCB Base, and disconnect
2 Connectors [3].
Fig. 5-018
(3) Remove the Ground Lead [4] and 3 Screws [5],
and pull down the PCB [6] towards you.
Fig. 5-019
(4) Remove the Harness Leads [8] from 2 Edge
Saddles [7], and remove the PCB Base.
Fig. 5-020
(5) Remove 3 Screws [9], and remove the Feed
Drive Unit [10].
[1]
[1]
[2]
[3]
[6]
[5]
[5]
[4]
[7]
[7]
[8]
[9]
[9]
[9]
[10]