Panasonic DP-3510

632
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Fig. 7-021
e. Close the Inlet Door while holding it down with your hand.
f. Press SW2 on the Saddle Stitch Controller PCB.
• The Saddle Stitch Unit will “stitch” the sheets, and fold and deliver the stack automatically.
g. Measure the distance (L) between the stitching position and the folding position. Then, perform
“positive width adjustment” or “negative width adjustment” to suit the relationship between the
stitching position and the folding position.
• If the stitching position is below the folding position, perform “positive width adjustment.”
• If the stitching position is above the folding position, perform “negative width adjustment.”
Fig. 7-022
h. Change the settings of bits 6 through 8 on DIPSW1 referring to Table 7-001 below.
• If the width adjustment is “0”,
The stitching position and the folding position match, requiring no change.
• If for “positive width adjustment,”
Set DIPSW1 so that the difference resulting from subtraction of the interval from the appropriate
setting in Table 7-001 is provided.
For instance, if the DIPSW1 is currently set to +2 and the interval is +1 mm, set DIPSW1 to reflect –
2.
• If for “negative width adjustment”
Set DIPSW1 so that the sum resulting from addition of the interval from the appropriate setting is
provided.
For instance, if the DIPSW1 is currently set to –1 and the interval is +0.5 mm, set DIPSW1 to reflect
+1.
Sheets
Mark
Unit: mm
Example: If L is 1 mm, provide “+1 mm”.
Folding position
Stitching position
Positive Width
Adjustment
Unit: mm
Example: If L is 0.5 mm, provide “-0.5 mm”.
Stitching position
Folding position
Negative Width
Adjustment