Panasonic DP-3510

633
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Do not touch the following:
Table 7-002
i. Set bits 1 through 4 on DIPSW1 to OFF.
11.1.7.1.3. Electrical System (Punch Unit (option))
1. Sensor Output Adjustment
Perform this adjustment when the Punch Driver PCB, Transmission Sensor (Photosensor PCB / LED
PCB) or Reflection Sensor (Punch Trash Box Full Detection PCB unit) has been replaced.
a. Remove the Rear Cover of the Finisher Unit.
b. Set bits 1 through 6 of DIPSW3 on the Finisher Controller PCB as indicated.
Fig. 7-024
c. Press SW1 on the Finisher Controller PCB.
Pressing this Switch automatically adjusts sensor output.
d. Set all bits on DIPSW2 to OFF.
2. Registering the Number of Punch Holes
This operation registers which Punch Unit is attached to the IC on the Punch Driver PCB so that the
Punch Unit can be identified by the Finisher. For this reason, this operation must be performed when
the Punch Driver PCB has been replaced. This operation, however, is not necessary on the Japanese
market as the 2-Hole Puncher is already registered as the default for new service parts.
The following describes a reference example of how to register the number of punch holes.
a. Remove the Rear Cover of the Finisher Unit.
b. Set bits 1 through 6 of DIPSW3 on the Finisher Controller PCB as indicated.
Fig. 7-025
c. Set bits 7 and 8 on DIPSW3 on the Finisher Controller PCB to match the number of punch holes of
DIPSW1 Bit Settings
Settings
(in units of 0.5 mm)
Bit 6Bit 7Bit 8
OFF ON ON +3
OFF ON OFF +2
OFF OFF ON +1
OFF OFF OFF 0
ON OFF ON -1
ON ON OFF -2
ON ON ON -3
Bit 6Bit 7Bit 8
ON OFF OFF
1
ON
2 3 4 5 6 7 8
1
ON
2 3 4 5 6 7 8