Panasonic DP-3510

765
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
3. Folding Position Sensor Delay Jam (1012)
In bind mode, the Folding Position Sensor does not detect paper 1200 msec after the Intermediate
Processing Tray starts to send paper to the stapling position.
Fig. 2-062
4. Folding Position Sensor Stationary Jam (1022)
In bind mode, paper does not leave the Holding Position Sensor approximately 10.5 sec after the
Staple/Fold Motor is driven.
Fig. 2-063
5. Door Open Jam (paper present)(1008)
The Finisher is disconnected from its host machine or the Front Door, or the Upper Cover is opened
while the system is in operation (paper on the move).
6. Staple Jam (1006)
The Staple Home Position Sensor (PI19) does not go OFF 600 msec after the Stapler is driven. Or, it
does not return to its home position (where the sensor goes ON).
7. Punch Jam
• Paper stuck at punch stapler
• Punching not ended 1 second after the punching request signal.
Jam Check
Folding Position
Sensor (PI10)
1200 ms
Normal
Delivery Motor (M3)
Jam Check
Folding Position
Sensor (PI10)
1200 ms
Jam
Delivery Motor (M3)
Jam Check
Folding Position
Sensor (PI10)
Staple/Fold
Motor (M7)
Approx. 10.5sec.
Normal
Jam Check
Folding Position
Sensor (PI10)
Staple/Fold
Motor (M7)
Approx. 10.5sec.
Jam