Panasonic HL-G1 Series - Page 44

Class Function Details
Initial value
Memory
chan
g
e*
Ref.
p
a
g
e
Zero-set
Sets the measurement value to zero. - 3-47
Reset
Resets the measurement value.
Default: OFF
-3-49
Buffering Settings
Bufferin
g
Mode
Sets the buffering mode.
Default: Continuous mode

3-52
Buffering Rate
Loads measurement data for a long duration by
decimating the measurement data during data
accumulation.
Default: 1/10

3-53
Accumulated Amount
Sets the amount of accumulated data.
Default: 3000 data items

3-53
Trigger Point
Sets the trigger generation position in the accumulated
data.
Default: 300

3-54
Trigger Delay
Delays the timing of accumulation after the trigger
generation.
Default: 0

3-54
Trigger Conditions
Sets the conditions of trigger generation.
Default: At timing input ON

3-55
Buffering Operation
Starts buffering with buffering-related parameters set
in advance.

3-56
Status Readout
Checks the operation status of accumulation. - 3-56
Last Data Point
Reads out the accumulation status from the amount of
measurement data.
- 3-56
Binary Readout of
Bufferin
g
Data
Reads out the accumulated data. - 3-57
㻌
* Memory change
{
: Up to four types of settings can be saved by performing memory
change.
¯
: Settings cannot be changed by performing memory change.
㻌

: Settings are saved as common settings for all memories. Settings cannot
be executed on a memory-to-memory basis.
㻌
㻌
 COM settings and buffering settings are functions dedicated to the high-function
type. These settings are not used for the standard type.
 Buffering settings cannot be made through the control panel. Make settings with
serial communications commands.
 Each set value is saved in either one of the following ways depending on the
operating method selected.
<Control panel of sensor head>
Press the [ENTER] key to save after a set value change is made.
<Serial communications command (High-function type only)>
Execute the “Save” command after making a setting change.
The execution of the “Save” command is required after making a setting change
in the case of using the Setting and Monitoring Software HL-G1SMI for the
dedicated console (sold separately).
㻌
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com