27
7.3.2. Double-feed Prevention Roller
(1) Turn off the scanner by turning the Power Switch off and
unplugging the AC Adaptor from the scanner. (See 7.2.1.)
(2) Remove the Feed Tray. (See 7.2.1.)
(3) Push the Door Open Button to open the ADF Door.
(See 7.2.1.)
(4) Open the Double-feed Prevention Roller Cover in the
direction of the arrow, holding the Double-feed Prevention
Roller not to drop out.
(5) Remove the Double-feed Prevention Roller.
(6) Take out a new Double-feed Prevention Roller from the
Roller Exchange Kit (KV-SS030).
(7) Install the new Double-feed Prevention Roller into the
metal holder with the longer groove facing to the right-side
(seen form the back), and close the Double-feed
Prevention Roller Cover.
Note:
Make sure to close the Double-feed Prevention
Roller Cover tightly, by pressing both ends of
the cover.
(8) Close the ADF Door slowly until it clicks into place.
(See 7.2.3.)
(9) After installing the Feed Tray, turn on the scanner by
plugging the AC Adaptor to the scanner and turning the
Power Switch on. (See 4.2 and 4.3.)
(10) Execute “Clear Counter” for replacing the Double-feed
Prevention Roller with Service Utility. (See 9.3.4.)
To Next Page
Loading...
