22
7.2. Cleaning
7.2.1. Preparation
Before cleaning, the following procedures are required.
(1) Turn off the scanner by turning the Power Switch off and
unplugging the AC Adaptor from the scanner.
(2) Remove the Feed Tray.
(3) Push the Door Open Button to open the ADF Door.
Note:
If the ADF Door does not open even with the
Door Open Button pushed repeatedly, there
is a possibility that the door is not latched.
In this case, try to close the ADF Door until it
clicks into place.
To Next Page
Loading...
Need help?
General