Panasonic KV-S1025C SERIES - Scanner Information; Scanner Counter

67
Fig. 9.3.2.3 Error Code
Note
*1
: Available for KV-S1025C Series Only
9.3.3. Scanner Information
This function provides various types of scanner information to an end-user or the service-person. Main contents are as follows.
(1) Model
(2) Firmware Version
(3) Board and Gate Array (LSI) version
(4) Interface
9.3.4. Scanner Counter
Classified
Code
Error Code Contents
ST1 ST2 ST3 ST4
- 00000000No error
- 0A 00 00 00 Stop by pushing "START/STOP Button"
- 0B 00 00 00 Stop by using the ADF stop-command
U11 11 00 00 00 Paper jam or (Double feed error)
U16 16 00 00 00 Paper jam (around Exit Roller) or (Double feed error)
U18 18 00 00 00 Document remains in the scanner.
U23 1C 00 x 00 Paper jam or (Double feed error)
(ST3: 0 Short interval between documents / 2: Length)
U30 20 00 00 00 Door open
F17 87 x 00 00 Access error to the SD-RAMs (IC1008, IC1009)
(ST2: 0 Access Error / 1: SD-RAM Error)
F31 95 00 00 00 Analog IC error
F33 97000000USB error
F34 98 00 00 00 Access error to EEPROM
F37 9B 01 x x Overrun error (ST3: Front Information, ST4: Back Information)
F60 50 00 00 x ST4 = 00: Front side gain error
/ ST4 = 80: White-standard area was not found.
F61 51 00 00 00 Front side black-level error
F62
*1
52 00 00 x ST4 = 00: Back side gain error
/ ST4 = 80: White-standard area was not found.
F63
*1
53 00 00 00 Back side black-level error
Item Operation Default Remarks
Update All
Counters
1. Click “Update All Counters” to update counter’s values.
2. Confirm the values of the “System”, “After Clean
Roller”, “After Replace Double-feed Prevention Roller”,
and “After Replace Paper Feed Roller” are updated on the
main menu.
—
Clear Counter
(After Clean
Roller)
1. Click “Clear Counter (After Clean Roller)” on the main
menu.
2. According to the message on the display, click “OK” to clear
the cleaning roller counter.
3. Confirm that the counter value is zero on the main menu.
— After cleaning (Paper Feed
and Double-feed Prevention)
Rollers, execute this item.
Clear Counter
(After Replace
“Double-feed
Prevention
Roller”)
1. Click “Clear Counter (After Replace Double-feed
Prevention Roller)” on the main menu.
2. According to the message on the display, click “OK” to clear
the roller replacement counter.
3. Confirm that the counter value is zero on the main menu.
— After replacing the
Double-feed Prevention
Roller, execute this item.
Clear Counter
(After Replace
“Paper Feed
Roller”)
1. Click “Clear Counter (After Replace Paper Feed Roller)”
on the main menu.
2. According to the message on the display, click “OK” to clear
the roller replacement counter.
3. Confirm that the counter value is zero on the main menu.
— After replacing Paper Feed
Roller, execute this item.