44
8.3.2. Conveyor Roller
(1) Remove the Side Cover (R). (See 8.2.1.)
(2) Remove the Side Cover (L). (See 8.2.2.)
(3) Remove the Bottom Cover. (See 8.2.3.)
(4) Remove the screw (a) and the Tension-plate Assembly
with the spring. And remove the 2 screws (b) and the
Side-plate Assembly.
(5) Remove the Conveyor Belt from the Conveyor Roller.
Reassembling Note: Tension-plate Assembly
See 8.3.1.
(6) Pull and remove the Pulley of the Conveyor Roller in
the direction of the arrow, while unlocking the stopper on
the pulley.
Note:
After reassembling the Pulley, be sure to check
the Pulley's lock to the Conveyor Roller by
pulling the pulley.
To Next Page
Loading...
