47
8.3.3. Exit Roller
(1) Remove the Front Cover. (See 8.2.4.)
(2) Remove the screw (a) and the Tension-plate Assembly
with the spring. And remove the 2 screws (b) and the
Side-plate Assembly.
(3) Remove the Conveyor Belt from the Exit Roller.
Reassembling Note: Tension-plate Assembly
(including BELT LAYOUT)
See 8.3.1.
(4) Pull and remove the Pulley of the Exit Roller in the
direction of the arrow while unlocking the stopper on the
pulley.
Reassembling Note:
After reassembling the Pulley, be sure to check
the Pulley's lock to the Exit Roller by pulling the
pulley.
To Next Page
Loading...
