Panasonic KV-S1025C SERIES - Page 74

74
Note
*2
:
Every time you push the “START/STOP Button”, Lamp ON/OFF status will change periodically, as follows.
(1) In case of KV-S1025C Series
Lamp (F) OFF / Lamp (B) OFF → Lamp (F) ON / Lamp (B) OFF → Lamp (F) OFF / Lamp (B) ON
→ Lamp (F) ON / Lamp (B) ON → Lamp (F) OFF / Lamp (B) OFF →.......
(2) In case of KV-S1020C Series
Lamp (F) OFF → Lamp (F) ON → Lamp (F) OFF → .......
4.
*2
Lamp ON/ OFF
1. While pushing “START/STOP Button” on the
front panel, turn on the scanner.
——
2. Release the button at the time when the
LEDs change to the contents in the right
column. (LED (Red): ON / LED (Green): ON)
ON ON
3. Push the “START/STOP Button” once to
turn on the Lamp (F).
ON ON
4. Push the “START/STOP Button” once to
turn on the Lamp (B), and to turn off the
Lamp (F).
ON ON
5. Push the “START/STOP Button” once to
turn on the Lamp (F) and Lamp (B).
ON ON
6. Push the “START/STOP Button” once to
turn off the Lamp (F) and Lamp (B).
ON ON
7. Turn off the scanner to finish the test. — —
Test Item Operation LED Status Remarks
*1
LED
(Red)
*1
LED
(Green)