4.7 Setting ECO Mode
Enabling this mode reduces the amount of electricity consumed by the unit.
Note
• When ECO mode is enabled, the "Link Speed" setting changes as follows:
– Link Speed: "10M/Full"
*1
– PC port cannot be used
• When the ECO mode setting is changed, the unit will restart.
• When ECO mode is enabled, is displayed in the status bar.
*1
The port of the switching hub to which the unit is connected must be 10 Mbps (Fixed) / full duplex.
To set
1. In standby mode, tap or , and then select "System Settings".
2. Tap or , and then select "System Settings".
3. Tap or , and then select "ECO Mode"
*1
.
4. Tap "On", and then tap "OK".
*2
*1
The administrator password may be required for this setting. Contact your administrator for further information. For available
characters, see “5.2 Character Table for Administrator Password".
*2
To disable ECO mode, select "Off" (default).
4.7 Setting ECO Mode
Document Version: 2017-08 Operating Instructions 103
To Next Page
Loading...
