2.7.5 Bluetooth Headset
Before using a Bluetooth headset, you need to register it to the unit.
Note
• During a conversation using a Bluetooth headset, the receiver volume can be adjusted using the
volume key on either the headset or the main unit.
• The connection status can be viewed on the status bar.
• Signals are transmitted between the unit and the Bluetooth headset using radio waves. For maximum
distance and noise free operation, it is recommended that the unit be situated away from electrical
appliances such as faxes, radios, personal computers, and microwaves.
• Privacy of communications may not be ensured when using the unit.
Registering a Bluetooth headset
Set the headset to pairing mode by following the instructions in the headset's documentation.
1. Tap or , and then select "Basic Settings".
2. Tap or , and then select "Bluetooth Headset".
3. Tap "Add New Device".
4. Enter the PIN, and then tap "OK".
*1
*1
For more information regarding the PIN, see the documentation for your headset.
Deregistering a Bluetooth headset
1. Tap or , and then select "Basic Settings".
2. Tap or , and then select "Bluetooth Headset".
3. Tap "Registration", and then tap "Yes".
Connecting a Bluetooth headset
1. Tap
or , and then select "Basic Settings".
2. Tap or , and then select "Bluetooth Headset".
3. Tap "Connection", and then tap "On".
4. Tap "OK".
Disconnecting a Bluetooth headset
1.
Tap or , and then select "Basic Settings".
2. Tap or , and then select "Bluetooth Headset".
3. Tap "Connection", and then tap "Off".
4. Tap "OK".
2.7.5 Bluetooth Headset
54 Operating Instructions Document Version: 2017-08
To Next Page
Loading...
