Note
• When a function key is assigned as a Line key, if you press a Line key other than the one for the
current call, the call is put on hold or is disconnected depending on the Automatic Call Hold settings.
For details, contact your phone system dealer/service provider.
To retrieve a call on hold at your line
1. Press
/ / HOLD .
2. When two or more lines are on hold, tap
or , and then select a line on hold.
Note
• When a call is received while another call is on hold, pressing and releasing the hook switch will
answer the call.
• If a function key is assigned as a Line key, and a call is on hold on that line, you can retrieve the call
on hold by following the step below.
1. Press the corresponding function key.
3.4.3 Holding in a System Parking Zone (Call Park)
You can use this feature as a transferring feature.
When Call Park is permitted, the "Park" icon is displayed. However, the Call Park feature number must be
set beforehand. Also, depending on your phone system, you may need to enter a parking zone number to
retrieve a parked call. The feature depends on your phone system. Contact your administrator for further
information.
To set
1. Press
/ MENU during a conversation.
2. Tap "Park" or press an unused (LED is off) function key to which the Call Park function is assigned.
3. Go on-hook.
To retrieve (Call Park Retrieve)
1. In standby mode, enter the Call Park Retrieve feature number or press a function key in use (blue LED
is slowly flashing, or red LED is slowly flashing) to which the Call Park function is assigned.
2. Go off-hook.
Note
• Depending on the telephone system, may be displayed in the status bar. In this case, you can
retrieve the call by pressing / MENU and then tapping "Park". However, to retrieve a parked call
using the icon, the Call Park Retrieve feature number must be set beforehand. Contact your
administrator for further information.
3.4.4 Talking to Two Parties Alternately (Call Splitting)
When talking to one party while the other party is on hold, you can swap the calls back and forth
(alternately).
To alternate between the parties leaving one party on hold temporarily
1. Press / / HOLD during a conversation.
3.4.3 Holding in a System Parking Zone (Call Park)
64 Operating Instructions Document Version: 2017-08
To Next Page
Loading...
