Panasonic KX-HDV430

2.2.6 Connections (including optional KX-HDV20)
Connect the Ethernet cable, the Handset Cord and the AC adaptor (option) to the unit.
Notice
• The KX-HDV20 can be used only when the product receives power from the optional AC adaptor; it
cannot be used when the product receives power via Power-over-Ethernet (PoE).
KX-HDV330 / KX-HDV430 / KX-HDV20
*2
*1
*4
*3
*5
*6
*1
Connection cable
Connect the connection cable as shown in the illustration.
*2
PoE HUB
*3
LAN cable
*4
Optional AC adaptor
*5
Optional EHS headset
For up-to-date information about EHS headsets that have been tested with this unit, refer to the following web site:
https://panasonic.net/cns/pcc/support/sipphone/
*6
Optional headset
For up-to-date information about headsets that have been tested with this unit, refer to the following web sites:
https://panasonic.net/cns/pcc/support/sipphone/
Note
• The initial setting for the IP address is "DHCP–Auto". For information about your network
environment, contact your administrator.
When selecting Ethernet cables (not included)
• Use flexible cables without jack covers. Do not use cables with a hard coating that may tear or crack
when bent. To prevent damage to the cables, use cables that do not protrude from the bottom of the
base.
• Connect the cables as shown in the following illustration.
2.2.6 Connections (including optional KX-HDV20)
22 Operating Instructions Document Version: 2017-08