Panasonic KX-HDV430

3.11 Communication Camera (KX-HDV430 only)
By registering a Communication Camera and then selecting it from the list, you can make a call to monitor
the camera’s video feed and allow voice communication.
When a call is received from a Communication Camera, you can monitor video feed of the other party.
You can operate the Communication Camera (pan/tilt), zoom in/zoom out the video feed, and control
devices connected to the Communication Camera (for example, to unlock a door). These features can be
used with KX-NTV150 and KX-NTV160 models.
This chapter describes the special functions and operations of the Communication Camera.
Refer to the relevant sections of this manual for operations not described here.
3.11.1 Using a Communication Camera
Registering a Communication Camera
You can register up to 16 Communication Cameras connected to the network.
1. In standby mode, tap
or , and then select "Basic Settings".
2. Tap or , and then select "Comm. Camera".
3. Tap or , and then select the number you want to register.
4. Enter the necessary information.
• Name
Specify the camera's name. You can enter up to 24 characters.
• Phone Number
Enter the phone number of the Communication Camera.
• Ringer Type
Set the ringtone for when a call is received by the Communication Camera. The default is "Ringtone
10".
Calling a Communication Camera
1. In standby mode, tap or , and then select "Comm. Camera".
2. Tap or , and then select the Communication Camera to call.
3. Tap "Camera Monitor" to monitor the video.
Tap "Camera Call" or go off-hook to make a voice call.
Note
• To make a voice call while monitoring a video feed, tap the screen, and then tap
or go off-hook.
• When a call is made by dialing a phone number, the video call screen is displayed.
Receiving a Call from a Communication Camera
• When a call is received, only one ring will be heard from the speaker.
• When a call is received, the camera's video feed is displayed. Then, to enable voice communication, tap
the screen, and then tap
.
• While on a voice call with a Communication Camera and a call is received from another Communication
Camera, tap "Camera" to answer the call. The current call will be put on hold.
Transferring a Call with a Communication Camera
For details about this operation, see "3.4.1 Transferring a Call (Call Transfer)".
3.11 Communication Camera (KX-HDV430 only)
Document Version: 2017-08 Operating Instructions 89