2.2.7 Wall Mounting
The KX-HDV330 / KX-HDV430 and up to 5 optional KX-HDV20 units can be mounted on a wall.
Notice
• When inserting screws, avoid pipes and electrical cables, etc., that may be present/buried.
• The screw heads should not be flush to the wall.
Note
• Make sure that the wall and the fixing method are strong enough to support the weight of the unit.
• You can find a wall mounting template at the end of this manual.
• Certain types of wall may require plugs to be anchored in the wall before the screws are inserted.
1. Insert the tabs of the wall mounting adaptor into the designated openings in the base, and then slide the
wall mounting adaptor in the direction of the arrow until it clicks.
KX-HDV330 / KX-HDV430
With optional KX-HDV20
For 2nd to 5th KX-HDV20
Remove the screw from the DSS cover of the KX-HDV20, and then slide the cover up to remove it.
*1 DSS cover
2. Fasten the wall mounting adaptor to the base with the small screw.
(Recommended torque: 0.4 N·m [4.08 kgf·cm / 3.54 lbf·in] to 0.6 N·m [6.12 kgf·cm / 5.31 lbf·in])
3. Connect the AC adaptor, handset cord, Ethernet cables, and connection cable as necessary.
2.2.7 Wall Mounting
24 Operating Instructions Document Version: 2017-08
To Next Page
Loading...
