Maintenance Console Location
3.14 [1-1] Slot—Card Property - Virtual IP Extension
Programming Manual References
None
Feature Guide References
1.31.1 IP Proprietary Telephone (IP-PT)
Keep Alive Time-Out
Specifies the length of time that the PBX will continue to consider an IP-PT to be active even if it receives no
transmissions from that IP-PT. The PBX constantly confirms the status of IP-PTs. If no communications are
received from an IP-PT for the duration specified here, the PBX considers the IP-PT to be unreachable, and
sets the port status to Fault.
During
operation, set between 10 s and 60 s. Settings over 60 s, and Disable, are used for debugging purposes,
and IP-PTs cannot be guaranteed to function normally in these circumstances. Do not use debugging settings
unless instructed to do so.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
Disable, 10–120 s
Maintenance Console Location
3.14 [1-1] Slot—Card Property - Virtual IP Extension
Programming Manual References
None
Feature Guide References
1.31.1 IP Proprietary Telephone (IP-PT)
First Resending Time (PTAP)
Specifies the length of time that the PBX waits before starting to resend PTAP (Panasonic Telephony
Administration Protocol) data.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
500 ´ n (n=1–16) ms
Maintenance Console Location
3.14 [1-1] Slot—Card Property - Virtual IP Extension
188 PC Programming Manual
3.14 [1-1] Slot—Card Property - Virtual IP Extension
To Next Page
Loading...
