Programming Manual References
None
Feature Guide References
None
CPC Detection Time—Out, In
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming trunk calls
before disconnecting the line. When None is selected here, the line will not be disconnected when a CPC
signal is not detected.
Value Range
None, 80 ´ n (n=2–75) ms
Maintenance Console Location
3.44 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
1.11.10 Calling Party Control (CPC) Signal Detection
DTMF Width
Selects the length of the DTMF tone sent to the E1 channel.
Value Range
80 ms, 160 ms
Maintenance Console Location
3.44 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
None
CO Pulse Speed
Selects the speed at which pulse dials are sent to the
E1 channel.
PC Programming Manual 389
3.44 [1-1] Slot—Port Property - E1 Port
To Next Page
Loading...
