Value Range
10 pulse/s, 20 pulse/s
Maintenance Console Location
3.44 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
1.5.4.4 Dial Type Selection
Wink Signal Time-Out
Specifies
the length of time that the PBX waits to receive a wink signal after seizing a trunk. If a wink signal is
not received before this timer expires, the trunk is released.
Value Range
64 ´ n (n=1–128) ms
Maintenance Console Location
3.44 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
None
Start Signal Type
Selects the type of the start signal.
Value Range
Immediate: Sends the dialled digits to the trunk when the First Dial Timer expires.
Wink: Sends the dialled digits to the trunk when the wink signal is received.
Maintenance Console Location
3.44 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
390 PC Programming Manual
3.44 [1-1] Slot—Port Property - E1 Port
To Next Page
Loading...
