Panasonic KX-TA624 - CPC Detection for Outgoing Calls; Disconnect Time

4-54 System Programming
[421]-[422] 4.2 System Programming
Enables or disables the CPC signal detection during an outgoing outside call. If disabled,
the CPC signal detection is only activated during an incoming outside call or after call hold.
* Exchange line number: 1 through 6 / (All exchange lines)
Default All exchange lines – Disable
• Feature Reference
Section 3, Features
Calling Party Control (CPC) Signal Detection
[421] CPC Detection for Outgoing Calls
1
2
4
NEXT
END
exchange line no.*
SELECT
(Enable/
Disable)
Determines the amount of time to send the disconnect signal from the system to the Local
Exchange or host PBX. The time you select must be longer than the requirement of your
Local Exchange or host PBX.
* Exchange line number: 1 through 6 / (All exchange lines)
Default All exchange lines – 2.0 seconds
• Feature Reference
Section 3, Features
Recall
(0.5/2.0/
4.0 sec)
[422] Disconnect Time
2
2
4
NEXT
SELECT
END
exchange line no.*
(1 ··· 6/ )
(1 ··· 6/ )
SELECT
SELECT
☞
☞
NEXT
PREV
or
To continue
STORE
NEXT
PREV
or
To continue
STORE
To continue
To continue
PSQX1708ZA-09E.QX 99.10.15 1:04 PM Page 54