• Be sure the handset is on the cradle and the SP-PHONE button is off.
• After programming, return the MEMORY switch to the “SET” position.
• See the Installation Manual, Section 3, “Direct Inward System Access (DISA)”.
• See the Installation Manual, Section 3, “Uniform Call Distribution (UCD)”.
• See the Installation Manual, Section 3, “Outgoing Message (OGM)”.
1.8 Operator / Manager Service Features
Operations 1-93
Operator / Manager
/ DSS Console Operations
☞
!
!
Outgoing Message (OGM)
The operator or manager can record or play back the outgoing message.
This is played when a caller accesses the DISA or UCD feature.
Two Outgoing Messages (OGM 1 and OGM 2) are available for DISA 1, DISA 2, UCD and
UCD-END.
To program, set the MEMORY switch on the proprietary telephone to “PROGRAM”.
Recording a message
PT
Dial 9.
9
Lift the handset. Dial 0 for both OGM 1 and OGM 2.
Dial 1 for OGM 1.
Dial 2 for OGM 2.
Record a message
(up to 30 seconds).
Press AUTO DIAL/STORE.
AUTO DIAL
STORE
Confirmation
tone
Confirmation
tone
10
or
2
or
• The STORE indicator light turns off. Recording
starts after the confirmation tone.
• The STORE indicator light turns steady red.
• If you exceed the time (30 seconds), recording is stopped automatically.
PT
Dial 9.
9
Dial 3 for OGM 1.
Dial 4 for OGM 2.
3 4
or
Playing back a message
• The STORE indicator light turns off.
• The message is played back.
PSQX1709ZA-07.QX 99.10.15 9:59 AM Page 93
To Next Page
Loading...
