• This feature will not work if you answer an incoming call or retrieve a call on hold.
• Up to 32 digits, consisting of “0 through 9” and “ ”, can be stored. The “ ” button is used
as a PAUSE. However, in the account code verify-all, verify-toll (call barring) and forced
modes, “ ” is not regarded as a pause.
• An account code must be stored by pressing “ ” and entering the account code after the
line access code.
• During the waiting time after going off-hook, you can call another party and override this
feature. You can change the waiting time between going off-hook and automatically dialling
through System Programming.
• A rotary telephone cannot use this feature.
• See the Installation Manual, Section 3, “Pickup Dialling”.
!
!
1-26 Operations
1.3 Making Calls
Dialling by Simply Going Off-Hook (Pickup Dialling)
Allows you to make an outgoing call by just going off-hook (single line telephone only).
Storing a phone number
SLT
Confirmation
tone and
dial tone
Lift the handset or press
SP-PHONE/MONITOR.
7 4 2 #
Dial 742.
Enter the phone number.
phone no.
Dial #.
Hang up or press
SP-PHONE/MONITOR
.
• You must dial a line access code (9, 0 or 81 through 86) as the
first digit when storing an external phone number.
SLT
Confirmation tone
and dial tone
Lift the handset or press
SP-PHONE/MONITOR.
Hang up or press
SP-PHONE/MONITOR.
To set: Dial 741#.
To cancel: Dial 740#.
7 4 1
To set.
7 4 0
#
#
To cancel.
Setting / Cancelling
SLT
Lift the handset or press
SP-PHONE/MONITOR.
Wait for an answer.
Talk.
Dialling
☞
PSQX1709ZA-03.QX 99.10.15 9:56 AM Page 26
To Next Page
Loading...
