1.7 Useful Features
Operations 1-61
Advanced Operations
• 1.2 Proprietary Telephone Settings, “Customising the Buttons on Your Telephone”,
CONF (Conference) Button
• 1.3 Making Calls, “Interrupting an Existing Call (Executive Busy Override)”,
Executive Busy Override — Extension,
Executive Busy Override — Exchange Line
• See the Installation Manual, Section 3, “Conference (3-party)”.
☞
!
!
• A conference call can also be established by “Executive Busy Override”.
• When a 2-party call is changed to a 3-party call or vice versa, a confirmation tone is sent to
all parties. The tone can be disabled.
• Pressing a line key which is not in the conference allows you to exit from the conference,
leaving the other two parties connected unless they are both exchange lines.
If the other parties are both exchange lines, they will be disconnected.
• If the third party does not answer, press the line key or INTERCOM button to return to the
second party.
• To change a 3-party conference to a 5-party conference, refer to “Conference (5-party)”.
• You can return to the original party before the third party answers by pressing the Recall
button.
• If “Hold-2” or “Hold-3” is assigned in System Programming, you must dial “50” after
pressing the Recall button.
SLT
SLT
PT
PT
PT
PSQX1709ZA-05.QX 99.10.15 9:58 AM Page 61
To Next Page
Loading...
