1.7 Useful Features
1-68 Operations
• In the Verify-All mode, you must always enter a pre-set account code when making an
outside call. In the Verify-Toll (Call Barring) mode, you can enter a pre-set account code
only when you need to override call barring.
• You do not need to make an account code entry when receiving incoming calls.
• You can clear and re-enter a number by pressing “ ” or the FWD/DND button while
entering an account code.
• An account code can be stored into Auto Dialling (“One-Touch Dialling”, “Pickup
Dialling”, “System/Personal Speed Dialling”, “Call Forwarding — to Exchange Line”). To
store an account code, “
” must be entered before the account code.
Example (Pickup Dialling):
— [Off-hook] [742] [Line Access Code] [ ] [Account Code] [Phone Number] [
#]
[On-hook]
• If the account code entered does not match the pre-set account code in the verify-all mode,
when making an outside call, reorder tone is heard.
• An account code has 4 digits (0 through 9). RECALL, PAUSE, etc. cannot be used.
• See the Installation Manual, Section 3, “Station Message Detail Recording (SMDR)”.
• See the Installation Manual, Section 3, “Account Code Entry”.
• See the Installation Manual, Section 3, “Call Barring Override by Account Codes”.
PT
!
!
☞
PSQX1709ZA-05.QX 99.10.15 9:58 AM Page 68
To Next Page
Loading...
