Panasonic KX-TD500 - Page 128

User Programming
128 User Manual
Programming
Display PT
Dial 005. Enter an extension number
(3 or 4 digits).
005
extension no.
Press NEXT.
NEXT
<PT Display> <PT Display>
EXT NO? →
To enter the lowest extension
number, you can also press NEXT.
<PT Display Example>
Repeat these steps
PT-PGM Mode
005 FLEXIBLE CO
To program another CO button of the same extension port:
CO
button code parameters
STORE
<To end:>
To program another extension port:
Press END.
END
Press SELECT.
SELECT
Enter an extension number
(3 or 4 digits).
extension no.
Go to "Repeat these steps"
above.
Repeat these steps.
The display shows the contents
pre-assigned to the button.
<PT Display Example>
CO-10101
To change the parameter, press CLEAR
and enter the new parameter.
Press CO which is changed
to another button.
Press STORE.Enter a button code. Enter parameters, if required.