Station Features and Operation (PT/SLT)
192 User Manual
• It is possible to disable the Hold Recall tone by System Programming <Section 2.5 System
Timer, "Hold Recall Time" in the Programming Guide>.
• Automatic Disconnection
If an inside / outside call put on hold is not retrieved within 30 minutes, it is disconnected
automatically.
• The number of calls that can be placed on (exclusive) hold at an extension
It differs depending on the telephone type as follows.
Intercom calls
– <ICM type PT> One, <SLT>: One (Not available)
– <DN type PT>: as many intercom calls as the number of DN (PDN, SDN) buttons on it.
Outside calls
– <ICM type PT>: as many outside calls as the number of CO (S-CO, G-CO, L-CO) buttons
on it.
– <DN type PT>: as many outside calls as the number of CO (S-CO, G-CO, L-CO) buttons
and DN buttons on it.
– <SLT>: One (Not available)
• An SLT user can hold only one call, either an intercom or outside, at a time. To hold multiple
calls, use the Call Park feature.
• Tenant Service
If "Tenant Service" is utilized, retrieving a held call (intercom or outside) is only available
within the same tenant.
• Confirmation Tone
A confirmation tone is sent to the extension user who retrieved the held call, when it is
retrieved by dialing the feature number.
This tone can be eliminated by System Programming <Section 2.8 System Option, "9.
Confirmation tone for Call Pickup, Paging, Paging – Answer, TAFAS – Answer, Hold
Retrieve and Call Park Retrieve">.
• The extension user cannot retrieve the following calls.
– Unattended Conference Calls
– Calls held at the System Call Parking Area
– Calls placed on Exclusive Call Hold
Programming Guide References
• 2.2 Tenant
– Music on Hold Source
• 2.3 Numbering Plan
– Hold
– Hold Retrieve – Station
– Hold Retrieve – Trunk
– Call Waiting Set/Cancel
• 2.5 System Timer
– Hold Recall Time
• 2.8 System Option
To Next Page
Loading...
