Panasonic KX-TD500 - Page 229

Station Features and Operation (PT/SLT)
User Manual 229
To terminate the 5-party conference (conference originator only)
Conditions
• Up to two 5-party conference calls can be held at a time in the system, even if TSW
Conference Expansion card is installed on the TSW card.
• Conference call arrangement
A 5-party conference call can include both inside and outside parties in any combination.
• Conference trunk
At least three idle conference trunks are required to establish a 5-party conference call.
• Executive Busy Override
Executive Busy Override does not function to the extension engaged in the 5-party
conference call.
• CONF (Conference) button
If a CONF button is not provided on a PT, it can be assigned to a flexible (CO, DSS, PF)
button by Station, User or System Programming.
• If the other party you called is in one of the following status, you can terminate the current
call and call a new party by pressing the FLASH button.
– the other party does not answer the call.
– the other party refuses to join a five-party conference call.
– the other party is a Voice Mail extension.
Programming Guide References
• 2.3 Numbering Plan
– Call Park / Call Park Retrieve
• 4.3 Extension Line
– CO Key
– PF Key
• 4.4 DSS Console
– DSS Key
– PF Key
PT
All other participants are disconnected from the call.
OR
(CO)
(DN)
or
Press an idle CO or DN
button.
During the 5-party conference call
Hang up or press
SP-PHONE/MONITOR.