Station Programming
52 User Manual
Confirming the assigned function data
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
—To exit the Station Programming mode: Press [PROGRAM].
— If you wish to change the data, follow the programming procedure explained in this section.
* A programming access number is required to program/confirm the function data by Station
Programming.
PT
Press HOLD (END).
Enter the program access number.
program access number
HOLD
Enter the program access number* as follows.
- 1:Preferred Line Assignment
-
Outgoing
- 2:Preferred Line Assignment
-
Incoming
- 3:Full One-Touch Dialing Assignment
- 4:Intercom Alert Assignment
- 5:Call Waiting Tone Type Assignment
- 6:Self-Extension Number Confirmation
- 7:Live Call Screening Mode Set†
-81:Initial Display Selection
-82:Bilingual Display Selection
- 9:Handset/Headset Selection
-01:Remote Station Look Control (
-
Operator / Manager only)
-02:Call Log Lock Control, Incoming (
-
Operator / Manager only)
-03:Live Call Screening Password Control (
-
Operator / Manager only)
- #:Station Programming Data Default Set
The display shows the programmed data.
<PT Display Example>
When you press [5], the display shows:
(
-
The Call Waiting tone is currently programmed to Tone 1.)
The display shows the initial programming mode.
C.W. Tone1
† Available when the Digital Super Hybrid System is connected to a Digital Proprietary Telephone capable Panasonic
Voice Processing System (one that supports Digital Proprietary Telephone [DPT] integration; e.g., KX-TVS100).
To Next Page
Loading...
