Panasonic KX-TD500 - Page 80

Station Programming
80 User Manual
– [EXT No.2] Group No.
Two-Way Transfer Button (Assignment)
*1
Allows you to assign a Flexible (CO, DSS) button as a Two-Way Transfer button.
This allows you to record a conversation into a desired mailbox.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
— To exit the Station Programming mode: Press [PROGRAM].
Conditions
• You cannot enter a non-existent extension or floating directory number.
*2
Please refer to "Floating Station" of Section "1.3 System Features" in the Features Guide.
• You should use a voice mail extension number that has been assigned by System
Programming. Please refer to Programming Guide References below.
Programming Guide References
• 1.5 VPS (DPT) Port Assignment
– [EXT No.1] DN
*1
Available when the Digital Super Hybrid System is connected to a Digital Proprietary Telephone capable Panasonic Voice
Processing System (one that supports Digital Proprietary Telephone [DPT] integration; e.g., KX-TVS100).
*2
A Floating Directory Number (FDN) is a virtual extension number which appears to be an extension.
<PT Display Example>
<PT Display Example>
(-xxxx:VM extension number)
To erase an incorrect entry, press the CLR (S2) button or the
TRANSFER (CLEAR) button.
(The TRANSFER button becomes the CLEAR button in the Station
Programming mode.)
2 WAY-TRANS:
CLR
2 WAY-TRANS:xxxx
CLR
PT
Press the desired Flexible
(CO, DSS) button you wish
to assign as the Two-Way
Transfer button.
Dial 91.
Press STORE.
Enter the Voice Mail
extension number
(3 or 4 digits).
Voice Mail
extension no.
AUTO DIAL
STORE
1
9
The STORE indicator lights.
The display shows the initial
programming mode.