[Fixed Numbering Table (available while dialing or talking)]
Feature Fixed Numbering
Pulse to Tone Conversion
Conference 3
Door Open 5
Conditions
• The
following are examples of feature number conflicts: 1 and 11, 0 and 00, 2 and 21, 10 and 101, 32 and
321, etc.
• Feature number + Additional number (Parameter)
Certain flexible feature numbers require additional digits to make the feature active. For example, to set
Call Waiting, the feature number for "Call Waiting" must be followed by "1" and to cancel it, the same feature
number should be followed by "0".
• Rotary single line telephone (SLT) users cannot dial feature numbers which include "
" or "#".
• Portable station (PS) users cannot use the following features:
– Personal Speed Dialing
– OGM playback/record
– S-CO Line Access
– Parallel Telephone Mode set/cancel
– Walking Extension
– BGM set/cancel
– Timed Reminder
• A PS can only be assigned an extension number of 4 digits or less.
PC Programming Manual References
4.8 [2-6-1] Numbering Plan
—Main
→Extension
→Features
→Other PBX Extension
4.9 [2-6-2] Numbering Plan—Quick Dial
4.10 [2-6-3] Numbering Plan—B/NA DND Call Feature
PT Programming Manual References
[100] Flexible Numbering
Feature Manual References
13.1.24 PS (Portable Station)
19.1.3 Voice Mail (VM) Group
21.1 Capacity of System Resources
Operating Manual References
4.2.1 Feature Number Table
Document Version 2010-11 Feature Manual 117
6.1.4 Flexible Numbering/Fixed Numbering
To Next Page
Loading...
