101
4. Focus and Shutter (Drive Mode) Settings
When [š], [ ], [Ø], or [ ] in Auto Focus Mode is selected, you can change the
position and size of the AF area.
•
Perform the operation after canceling the touch shutter function.
• When setting with touch operation, set [Touch AF] in [Touch Settings] of the [Custom] menu to
[AF].
• The spot metering target can also be moved to match the AF area when the [Metering Mode]
(P161) is set to [ ]. At the edge of the screen, the metering may be affected by the brightness
around the AF area.
• If you set [Direct Focus Area] in the [Custom] menu to [ON], you can move the AF area with the
cursor buttons when [š], [ ], or [Ø] is selected, and you can move the enlarged part with
the cursor buttons when [ ] is selected. (P307)
Not available in these cases:
•
When using digital zoom, the position and size of the AF area cannot be changed.
Position and size of the AF area can be changed.
1 Press [].
2 Select [š] or [Ø] and press 4.
•
AF area setting screen is displayed.
• You can also display the AF area setting screen by
touching the screen.
3 Change the position and size of the AF area.
•
If you set the AF area over an eye in the yellow frame when [š] is selected, the eye to be
in focus will be changed. (P97)
Setting up position of the AF area/changing size of the AF area
Applicable modes:
When selecting [š], [Ø]
Button
operation
Touch
operation
Description of operation
3/4/2/1 Touching Moves the AF area.
Pinching in/
out
Enlarges/reduces the AF
area in small steps.
/ s
Enlarges/reduces the AF
area in large steps.
[DISP.] [Reset]
Resets the AF area back to
the center.
• If you press the button
again, the frame size will be
reset to the default setting.
To Next Page
Loading...
