303
10. Using the Wi-Fi/NFC Function
• For details on how to enter characters, refer to “Entering Text” section on P57.
• Make a copy of password.
If you forget the password, you can reset it with [Reset Wi-Fi Settings] in the [Setup] menu,
however other settings will also be reset. (excluding [LUMIX CLUB])
• A “MAC Address” is a unique address that is used to identify network equipment.
• “IP address” refers to a number that identifies a PC connected to a network such as the
Internet. Usually, the addresses for homes are automatically assigned by the DHCP function
such as a wireless access point. (Example: 192.168.0.87)
¢ [Approved Regulations] is only available on the version DMC-GH4P.
[Touch Sharing]
Sets the camera operation after the connection with the NFC
function is complete.
[ON]:
When a Wi-Fi connection is complete by using the NFC function
during single picture playback, the single picture can be
transferred.
[OFF]
[Wi-Fi Password]
To prevent incorrect operation or use of the Wi-Fi function by a
third party and to protect saved personal information, it is
recommended that you protect the Wi-Fi function with a
password.
Setting a password will automatically display the password input
screen when the Wi-Fi function is used.
[Setup]:
Enter any 4-digit numbers as the password.
[Delete]
[Network Address]
Displays the MAC address and IP address of this unit.
[Approved
Regulations]
¢
Displays the certification number for radio regulations.
To Next Page
Loading...
