Panasonic PT-REQ12 Series

Chapter 4 Settings — [PROJECTOR SETUP] menu
182 - ENGLISH
Note
f If no CEC-compatible device is connected to <HDMI IN 1> terminal, <HDMI IN 2> terminal or <SLOT> terminal, there is no device
displayed at [HDMI 1], [HDMI 2] or [SLOT] and [----] is displayed.
f Wireless Presentation System Receiver Board (Model No.: TY‑SB01WP) supports the power on/power o󰀨 link and the input switching
related to the power link of the CEC function. It does not support the menu operation of the CEC-compatible device using the projector
remote control.
f For the Function Board of other manufacturers and the CEC-compatible devices connected to the Function Board of other manufacturers,
not all the operations are guaranteed.
f To exit the HDMI CEC operation, press the <MENU> button.
Changing the menu code
The menu code that calls up the operation menu of the CEC-compatible device varies depending on the device
manufacturer. If you cannot call up the operation menu of a CEC-compatible device from the HDMI CEC operation
screen, change the menu code setting.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].
3) Press the <ENTER> button.
f The [HDMI CEC] screen is displayed.
4) Press as to select [MENU CODE].
5) Press qw to switch the item.
f The items will switch each time you press the button.
f Select the menu code from [1] to [6].
Setting the power link
Make settings for the power link operations between the projector and CEC-compatible devices.
[PROJECTOR -> DEVICE]
Set the power link operation from the projector to the CEC-compatible device.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].
3) Press the <ENTER> button.
f The [HDMI CEC] screen is displayed.
4) Press as to select [PROJECTOR
->
DEVICE].
5) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
Disables the power link operation.
Select this item if you do not want the power status of the CEC-compatible device to react to the power status
of the projector.
[POWER OFF]
Enables power‑o󰀨 link operation.
When you turn o󰀨 the power of the projector and put it in standby mode, all CEC‑compatible devices
connected to the <HDMI IN 1> terminal, <HDMI IN 2> terminal and Function Board will enter standby mode.
Power-on link operation is disabled.
[POWER ON/OFF]
Enables power‑on link operation and power‑o󰀨 link operation.
If you turn on the projector and start projection, the CEC-compatible device connected to the <HDMI IN 1>
terminal, <HDMI IN 2> terminal or Function Board will turn on.
When you turn o󰀨 the projector and put it in standby mode, all CEC‑compatible devices connected to the
<HDMI IN 1> terminal, <HDMI IN 2> terminal and Function Board will enter standby mode.
[DEVICE -> PROJECTOR]
Set the power link operation from the CEC-compatible device to the projector.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].